Hw-module Slot
admin 3/28/2022
Hw-module Slot Rating: 5,0/5 4651 reviews
Can anyone comment on RSP redundancy with SSO mode? Hw-module subslot card slot/subslot number shutdown unpowered. Example: Device(config)# hw-module subslot 1/0 shutdown unpowered: Powers down the specified module by placing it in low power mode. Example: Device(config)# end: Exits the global configuration mode.
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've doneHw-module slot (7300) hw-module slot (7600) hw-module slot (ASR 1000 Series). Hello Experts I have attempted to install the sp4 (asr9k-px-5.3.3.sp4.tar)for IOS XR 5.3.3 in AR9006 However the install fails with a message about the state of 0/RSP1/CPU0. Can I install the SP4 in spite of the status of 0/RSP1/CPU0? Thanks in advance for your help below is the console log.
this:
service single-slot-reload-enable
redundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :
------------------------------ Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0 Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR = Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
Hw-module Slot R1 Stop
_______________________________________________Hw-module Slot Shutdown
Cisco Hw-module Slot
cisco-nsp mailing list cisco-nsp@puck.nether.netHw-module Subslot
https://puck.nether.net/mailman/listinfo/cisco-nsp